Hi! My OpenStack guide: https://gist.github.com/tmartinx/d36536b7b62a48f859c2 is based on two computers, each with only one NIC. ;-) Cheers! Thiago On 4 May 2013 16:34, Jing <vitojing at gmail.com> wrote: > Hi, I'm trying to set up Openstack on two computers, and each of them has > only one NIC. I want to set up one computer as control and compute node, > and another as compute node. I want to use vlan mode, so quantum is needed. > > I'm install Openstack according > > https://github.com/mseknibilel/OpenStack-Grizzly-Install-Guide/blob/OVS_MultiNode/OpenStack_Grizzly_Install_Guide.rst > > After install quantum server in first computer( used as control and > compute node ), I tried to install the "Network Node" functions. The NIC is > configured as follows: > > # The loopback network interface > auto lo > iface lo inet loopback > > auto eth0 > iface eth0 inet static > address 192.168.1.104 > netmask 255.255.255.0 > gateway 192.168.1.1 > dns-nameservers 8.8.8.8 > > In the "3.4. OpenVSwitch (Part2)" section of the guide, eth2 is cnfigured > as > > # VM internet Access > auto eth2 > iface eth2 inet manual > up ifconfig $IFACE 0.0.0.0 up > up ip link set $IFACE promisc on > down ip link set $IFACE promisc off > down ifconfig $IFACE down > > I don't have another NIC. How should I write the interface configuration > file? > And another question , is it possible to use wireless NIC in quantum? > > thanks > > _______________________________________________ > Mailing list: https://launchpad.net/~openstack > Post to : openstack at lists.launchpad.net > Unsubscribe : https://launchpad.net/~openstack > More help : https://help.launchpad.net/ListHelp > > -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://lists.openstack.org/pipermail/openstack/attachments/20130504/5382613d/attachment.html>