I want to improve the existing overall architecture diagrams and create new diagrams for chapters that typically require additional nodes such as Block Storage and Object Storage. However, that project will wait until after the installation guide stabilizes for Juno. On Tue, Oct 14, 2014 at 5:09 AM, Christian Berendt <berendt at b1-systems.de> wrote: > In the section "Configure a Block Storage service node" of the > installation guide we talk about a host named "block1". > > This host "block1" is not mentioned in the example architecture. There > are only the hosts "controller", "network" and "compute1". > > > http://docs.openstack.org/trunk/install-guide/install/zypper/content/cinder-install-storage-node.html > > Also the Cinder services on the storage nodes are not mentioned in the > figure "Figure 1.2. Three-node architecture with OpenStack Networking > (neutron)" in "Chapter 1. Architecture". > > > http://docs.openstack.org/trunk/install-guide/install/zypper/content/ch_overview.html > > Christian. > > -- > Christian Berendt > Cloud Solution Architect > Mail: berendt at b1-systems.de > > B1 Systems GmbH > Osterfeldstraße 7 / 85088 Vohburg / http://www.b1-systems.de > GF: Ralph Dehner / Unternehmenssitz: Vohburg / AG: Ingolstadt,HRB 3537 > > _______________________________________________ > OpenStack-docs mailing list > OpenStack-docs at lists.openstack.org > http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack-docs > -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://lists.openstack.org/pipermail/openstack-docs/attachments/20141014/bc9d6f46/attachment.html>