Open Stack

On 12/05, ManuParra wrote:
> Thanks, I have restarted the service and I see that after a few minutes then cinder-volume service goes down again when I check it with the command openstack volume service list.
> The host/service that contains the cinder-volumes is rbd:volumes at ceph-rbd that is RDB in Ceph, so the problem does not come from Cinder, rather from Ceph or from the RDB (Ceph) pools that stores the volumes. I have checked Ceph and the status of everything is correct, no errors or warnings.
> The error I have is that cinder can’t  connect to rbd:volumes at ceph-rbd. Any further suggestions? Thanks in advance.
> Kind regards.
>

Hi,

You are most likely using an older release, have a high number of cinder
RBD volumes, and have not changed configuration option
"rbd_exclusive_cinder_pool" from its default "false" value.

Please add to your driver's section in cinder.conf the following:

rbd_exclusive_cinder_pool = true


And restart the service.

Cheers,
Gorka.

> > On 11 May 2021, at 22:30, Eugen Block <eblock at nde.ag> wrote:
> >
> > Hi,
> >
> > so restart the volume service;-)
> >
> > systemctl restart openstack-cinder-volume.service
> >
> >
> > Zitat von ManuParra <mparra at iaa.es>:
> >
> >> Dear OpenStack community,
> >>
> >> I have encountered a problem a few days ago and that is that when creating new volumes with:
> >>
> >> "openstack volume create --size 20 testmv"
> >>
> >> the volume creation status shows an error.  If I go to the error log detail it indicates:
> >>
> >> "Schedule allocate volume: Could not find any available weighted backend".
> >>
> >> Indeed then I go to the cinder log and it indicates:
> >>
> >> "volume service is down - host: rbd:volumes at ceph-rbd”.
> >>
> >> I check with:
> >>
> >> "openstack volume service list”  in which state are the services and I see that indeed this happens:
> >>
> >>
> >> | cinder-volume | rbd:volumes at ceph-rbd | nova | enabled | down | 2021-04-29T09:48:42.000000 |
> >>
> >> And stopped since 2021-04-29 !
> >>
> >> I have checked Ceph (monitors,managers, osds. etc) and there are no problems with the Ceph BackEnd, everything is apparently working.
> >>
> >> This happened after an uncontrolled outage.So my question is how do I restart only cinder-volumes (I also have cinder-backup, cinder-scheduler but they are ok).
> >>
> >> Thank you very much in advance. Regards.
> >
> >
> >
> >
>
>