Open Stack

I see.

Perhaps it will be better if you can provide an error msg shared on
pastebin?

Alexandros Soumplis <soumplis at admin.grnet.gr> 於 2021年3月27日 週六 下午2:56寫道：

> Hi Eddie,
>
> If I define them in the hostname it works perfectly fine. I cannot use the
> globals.yml because there are different bridges per group (ex. control
> plane servers do not the provide network bridges).
>
> The problem with the host approach is that it makes the inventory file
> very difficult to parse with external scripts. If the typical ansible :vars
> section worked as expected it would make any parsing much easier with
> crudini :)
>
>
> a.
>
>
>
> On 27/3/21 1:11 π.μ., Eddie Yen wrote:
>
> Hi Alexandros,
>
> In the [compute] area, it's correct.
> But for define what physical interface should be use for each
> nodes, you should set like below:
>
> [compute]
> comp[1:5] neutron_external_interface=bond0.100,bond.101
>
> And I'm not sure if "neutron_bridge_name" can be set behind
> hostname. For me I usually put into globals.yml.
>
> Alexandros Soumplis <soumplis at admin.grnet.gr> 於 2021年3月27日 週六 上午1:49寫道：
>
>> Hi all,
>>
>> I am trying to define a couple of variables in the inventory file for a
>> specific group and I do something like the following in the inventory:
>>
>> (...)
>> [compute]
>> comp[1:5]
>>
>> [compute:vars]
>> neutron_external_interface=bond0.100, bond0.101
>> neutron_bridge_name=br-ex,br-ex2
>>
>> (...)
>>
>> This is a valid ansible setup, however with kolla-ansible these
>> variables are totally ignored. Any suggestion ?
>>
>>
>> a.
>>
>>
>>
>>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.openstack.org/pipermail/openstack-discuss/attachments/20210327/f6dffa92/attachment.html>