[Openstack] Baremetal - Hardware preparation
dj_dark_junglist at yahoo.com
Fri Aug 23 06:23:44 UTC 2013
I understand your points and that is taken care of, but how exactly is Openstack going to connect to the hardware if the hardware has no OS and no IP?
How should the hardware be prepared so I can give Openstack the information it needs to enroll the hardware?
From: "K, Shanthakumar" <shanthakumar.k at hp.com>
To: Jake G. <dj_dark_junglist at yahoo.com>
Cc: "openstack at lists.openstack.org" <openstack at lists.openstack.org>
Sent: Friday, August 23, 2013 3:08 PM
Subject: RE: [Openstack] Baremetal - Hardware preparation
Your physical hardware should be maximum enough to support your OS configurations and baremetal flavor you have created.
1. Your physical hardware should contain minimum configurations to run an operating system
2. You need to take care of your Baremetal Flavor created WRT to your available hardware.
From:Jake G. [mailto:dj_dark_junglist at yahoo.com]
Sent: Friday, August 23, 2013 10:07 AM
To: openstack at lists.openstack.org
Subject: [Openstack] Baremetal - Hardware preparation
I have been following this doc https://wiki.openstack.org/wiki/Baremetal#Image_Requirements
to setup openstack for baremetal provisioning. I have configured oopenstack properly, created an image,
and now I am ready to enroll my physical hardware. However, there seems to be no mention of how to
prepare my physical hardware.
Does anyone know what is required and what is the process to prepare my hardware?
Thank you for your help,
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Openstack