Open Stack

On Mon, Jan 20, 2014 at 10:30 AM, iKhan <ik.ibadkhan at gmail.com> wrote:
> Thanks John,
>
> It worked earlier while executing because iniparse was installed, tho this
> wasn't present in virtual environment. Installing iniparse via pip did work.
> Since I didn't install iniparse specifically, I was under impression it was
> there by default. Probably now I have to take care of this in
> test-requirement.txt as you mentioned.
>
> I wonder if there is an alternative to iniparse by default.
>
> Regards
>
>
> On Mon, Jan 20, 2014 at 10:47 PM, John Griffith
> <john.griffith at solidfire.com> wrote:
>>
>> On Mon, Jan 20, 2014 at 10:07 AM, iKhan <ik.ibadkhan at gmail.com> wrote:
>> > Hi,
>> >
>> > I have imported iniparse to my cinder code, it works fine when I perform
>> > execution. But when I run the unit test, it fails while importing
>> > iniparse.
>> > It says "No module named iniparse". Do I have to take care of something
>> > here?
>> >
>> > --
>> > Thanks,
>> > Ibad Khan
>> > 9686594607
>> >
>> > _______________________________________________
>> > OpenStack-dev mailing list
>> > OpenStack-dev at lists.openstack.org
>> > http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack-dev
>> >
>>
>> It sounds like it's not installed on your system.  You'd need to do a
>> "pip install iniparse", but if you're adding this to your unit tests
>> you'll need to have a look at the common test-requires file.  Also
>> keep in mind if your driver is going to rely on it you'll need it in
>> requirements.  We can work through the details via IRC if you like.
>>
>> John
>>
>> _______________________________________________
>> OpenStack-dev mailing list
>> OpenStack-dev at lists.openstack.org
>> http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack-dev
>
>
>
>
> --
> Thanks,
> Ibad Khan
> 9686594607
>
> _______________________________________________
> OpenStack-dev mailing list
> OpenStack-dev at lists.openstack.org
> http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack-dev
>

there is check out openstack.common.iniparser, not sure if it'll fit
your needs or not.