Unable to attach a Volume to Openstack WIndows instance
List, I am trying to import a multi disk Windows VM ( 100GB bootable disk and 600 GB data volume disk) exported from HyperV to Openstack(Ussuri, Qemu-KVM, Glance image store, Cinder volume with Ceph backend). I am able to import the First bootable disk(vhdx converted to qcow2 ) with Windows VM in the OpenStack and its up and running able to login. ONE BASIC queston I not perfomed the *"Virt IO Injection steps"* as I am not sure whether for existing Windows VMs exported from HyperV need this Injection or not . Some one can clarify or defend this statement * " That Any Windows VM with Volume disks attached to it running on Other HyperVisor( say HyperV in my case, oVirt) exported to openstack which uses qemu-kvm needed the VirtIO Injection must done before importing to OpenStack with KVM for these Windows VMs for up and running and for attaching volume disks which also exported from other hypervisors . " OR only performance improvement only VirtIO injection do, so that I can avoid VirtIO injection for importing WIndowsVMs with multi disk to OpenStack.* used this step to import the converted bootable disk to my openstack. # openstack image create “Your_Windows_VM_NAME_Blaah” --file Windows_VM_disk1.qcow2 --disk-format qcow2 --container-format bare --public --property hw_firmware_type=uefi --property os_secure_boot=required --property hw_disk_bus=ide I am trying to import the second disk # openstack image create “Your_Windows_VM_NAME_Blah” --file Windows_VM_disk2.qcow2 --disk-format qcow2 --public and tried to create Volume through horizon dashboard with this image and 600 GB space. But volume creation itself showing status creating for more than 1 hour for now . Is this usual behaviour or some this wrong ? Note: so this volume creation from image is taking long time. As trial and error method I tried to create a small plain volume and attach this to the running WIndows VM(Windows2012 RC). But failed. I tried to create a plain 20 GB volume from the Horizon GUI and its created with in 30 seconds.. And tried to attach this volume to the Windows VM disk1 which is running and not got attached. ( I shutdown the Windows VM and tried to attach) same result. not attached. A plain volume also unable to got attached to the Windows VM ? why ? But the large 600GB goes for long hours. ( yesterday also tried and it was in creating state for 5 to 10 hours and I was waiting with no use, then I used the cinder command to change the volume status to "available" and then removed the volume which had not yet changed the state from "creating" to ``available" . Why do these volume creations with large disk space go for hours ? Are there any short steps to make it fast ? Any hints most
participants (1)
-
KK CHN