<div dir="ltr"><div><div><div><div><div>Hi,<br><br></div>I'm seeking some advice on replacing a libvirt/manual setup with an openstack/VM based one. Most of the work has been done and seems to work, however, the existing setup has working IPv6 on the host as well as the guests -- something that I have failed to achieve so far with the OpenStack replacement.<br><br></div>My situation is a single host with a /64 subnet assigned. The guests and the host have been assigned an IP from the available /64 subnet. All traffic from the host and the guests needs to be routed upstream through fe80::1.<br><br></div>Everything works as long as I don't set up any IPv6 at all. But when I set up the external interface (enp4s0) with an IPv6 address (no matter which one), the linux bridge receives "File exists" errors from RTNETLINK.<br><br></div>Can anyone point me to configuration examples or installation documentation for the case I'm trying to configure? (Note that I have looked at this page: <a href="https://docs.openstack.org/mitaka/networking-guide/config-ipv6.html">https://docs.openstack.org/mitaka/networking-guide/config-ipv6.html</a> but the fact that it talks a lot about prefix delegation makes it very confusing, tbh...)<br><br></div>Thanks in advance for any advice you can provide!<br clear="all"><div><div><div><div><div><div><br>-- <br><div class="gmail_signature"><div dir="ltr">Bye,<div><br></div><div>Erik.</div><div><br></div><div><a href="http://efficito.com/" target="_blank">http://efficito.com</a> -- Hosted accounting and ERP.</div><div>Robust and Flexible. No vendor lock-in.</div></div></div>
</div></div></div></div></div></div></div>