Open Stack

Your setup should be fine.

Ensure, that you have created your openstack external network as flat
provider network (default with devstack). Then adding br-ex into the
vlan device enforces vlan traffic on the external network. 
An alternative approach would be to add the bond interface into the
br-ex (instead of its vlan device) and create your openstack external
provider network as vlan network using vlan 45.
Both should work!

In general take be aware, all the vlans you're using have to be enabled
in your hardware switch as well if it's not a 20$ device.

Andreas
(IRC: scheuran)


On Mo, 2015-06-15 at 17:31 +0000, Yngvi Páll Þorfinnsson wrote:
> Hi 
> 
> We‘re using Ubuntu 14.04 on all servers. Using 1 controller node, 2
> network nodes, 4 compute nodes as well as 4 swift nodes.
> 
>  
> 
> I‘ve been doing some changes on my network configuration and
> introducing vlans ( also bonding).
> 
> My goal is to have all networks running on one 10G interface, as
> VLANs. 
> 
> I‘ve done this already for the management- and tunnel network.
> 
> This is the setup:
> 
>  
> 
> bond0.48  - mgmt interface
> 
> bond0.47 – tunnel interface
> 
>  
> 
> and then I would add this one as well
> 
>  
> 
> bond0.45 – external interface
> 
>  
> 
> and then add the bridge:
> 
>  
> 
> # ovs-vsctl add-port br-ex
> 
> # ovs-vsctl add-port br-ex bond0.45
> 
>  
> 
> I could be wrong here, with the „bond0.45“ ...
> 
> So does it make sense to go this path?  Or more critical: is it
> possible to configure openstack like this?
> 
>  
> 
> On the previous setup, I did configure the external br-ex like this:
> 
>  
> 
> # ovs-vsctl add-port br-ex
> 
> # ovs-vsctl add-port br-ex em3
> 
>  
> 
> And defined be-ex and em3 in the interfaces file
> 
> /etc/network/interfaces
> 
> .
> 
> .
> 
> auto br-ex
> 
> iface br-ex inet static
> 
>         address ip-number
> 
>         netmask 255.255.255.0
> 
>         network xxxx
> 
>         dns-nameservers yyyy
> 
>         dns-search siminn.is
> 
>         gateway zzzz
> 
>  
> 
> auto em3
> 
> iface em3 inet manual
> 
> up ifconfig $IFACE 0.0.0.0 up
> 
> up ip link set $IFACE promisc on
> 
> down ip link set $IFACE promisc off
> 
> down ifconfig $IFACE down
> 
> .
> 
>  
> 
>  
> 
> Could I achive this and configure the external network bridge,
> br-ex, as a vlan ?
> 
>  
> 
> Best regards
> 
> Yngvi
> 
>  
> 
> 
> _______________________________________________
> Mailing list: http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack
> Post to     : openstack at lists.openstack.org
> Unsubscribe : http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack