<div dir="auto">Thanks for the info Arnaud. Looking into it now.<div dir="auto"><br></div><div dir="auto">Regards,</div><div dir="auto">Roshan</div></div><br><div class="gmail_quote"><div dir="ltr" class="gmail_attr">On Wed, Feb 17, 2021, 5:05 PM Arnaud Morin <<a href="mailto:arnaud.morin@gmail.com">arnaud.morin@gmail.com</a>> wrote:<br></div><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">Hello,<br>
<br>
I dont have the whole picture of your network architecture, but if it is<br>
correct you should have a tap interface in br-int for your instance.<br>
Then the br-int should be connected to br-ex through a patch (something<br>
like int-patch-ex or similar).<br>
<br>
The you should have a physical interface in br-ex (like eth2).<br>
<br>
You can also try to see if the DHCP agent succesfully created ports in<br>
your provider network (openstack port list, if you see some down ports,<br>
then you have an issue).<br>
<br>
Good luck!<br>
<br>
-- <br>
Arnaud Morin<br>
<br>
On 17.02.21 - 16:07, roshan anvekar wrote:<br>
> Hello Folks,<br>
> <br>
> Any suggestions on this??<br>
> <br>
> Thank you<br>
> <br>
> On Tue, Feb 16, 2021, 12:28 PM roshan anvekar <<a href="mailto:roshananvekar@gmail.com" target="_blank" rel="noreferrer">roshananvekar@gmail.com</a>><br>
> wrote:<br>
> <br>
> > Hello,<br>
> ><br>
> > I have tried multiple options of setting up the bridge interface for vlan<br>
> > provider network setup in stein. None is allowing the gm to get IP. Getting<br>
> > the same DHCP issue all the time.<br>
> ><br>
> > I tried with:<br>
> > 1. Setting provider network interface as as sub interface on a bond.<br>
> > Connecting bridge with it.<br>
> > 2. Setting bridge directly over bond.<br>
> > 3. Manual setup of bridge interface.<br>
> > 4. Allowing Openstack to setup bridge on the bond.<br>
> ><br>
> > None of this is working. All are giving the same DHCP issue.<br>
> ><br>
> > Also I m using a sub-interface on the same bond for TLS interface. Not<br>
> > sure if that's causing a issue.<br>
> ><br>
> > Error message in openvswitch container while running ovs-vsctl show<br>
> > command:<br>
> ><br>
> > *error: "could not add network device br-ex to ofproto (File exists)"*<br>
> ><br>
> > Any pointers for this issue??<br>
> ><br>
> > Regards,<br>
> > Roshan<br>
> ><br>
</blockquote></div>